Creating Holes

Hole lets you create a hole on an object. You can also select the required hole standards and presets and create the hole.

  1. Select the required face on which you want to create the hole.
  2. In the Hole.x dialog box,
    1. Select the required hole type from the list:

      Option Hole Type


      		Simple hole
      Tapered hole


      		Counter bored hole


      		Counter sunk hole


      		Counter drilled hole

    2. From the Geometric standard list, select the required hole standard, if applicable.
    3. Select the required description from the Geometric description list, if applicable.
    4. Configure the standard parameters, as applicable.
    5. Select the required anchor point, as applicable.
  3. Configure the hole parameters.
  4. Click OK.

    The hole is created. A hole node is added to the tree. In addition, the sketch that was used to create the hole also appears under the hole node in the tree.



 

See Also
About Holes