-
Select the profile to be extruded.
-
In the First Limit box, enter the pocket depth
value.
-
In the Second Limit box, select the top face as the
second limit.
Selecting a second limit is mandatory.
-
In the Draft Angle box, enter the draft angle value.
-
Select Second limit to define the neutral element. So,
note that the pad's top face is also used as the neutral element.
-
Select the respective check boxes and enter a radius value for each edge type
to define the three fillets as per the requirement.
-
Lateral radius: defines the fillets on
vertical edges.
-
Top fillet radius: defines the round corner fillets.
-
Bottom fillet radius: defines the filets on the edges of the second
limit.
|