Insulation Dimension

This section describes the Insulation Dimension table and how you can customize it.

This page discusses:

Overview

This section provides a brief overview of the Insulation Dimension table.

The Insulation Dimension table allows you to define a set of parameters for creating insulation.

In Data Setup, this table should be assigned to the Insulation Dimension item in the resource table of Piping/Tubing Specification Resources with a Standard criteria.

Table Description

To customize the table, enter all possible available in a resource set.

A typical Insulation Dimension table is shown below:

Nominal SizeMinimum TemperatureMaximum TemperatureInsulation TypeMaterialMaterial CategoryInsulation Thickness
2in50100ThermalStainless steelSteel0.0625
4in50100ThermalStainless steelSteel0.0625
10in50100ThermalStainless steelSteel0.125
12in50100ThermalStainless steelSteel0.1875
14in50100ThermalStainless steelSteel0.1875
20in50100ThermalStainless steelSteel0.1875
22in50100ThermalStainless steelSteel0.1875
32in50100ThermalIron steelSteel0.25
38in50100ThermalIron steelSteel0.25
40in50100ThermalIron steelSteel0.25
46in50100ThermalIron steelSteel0.25
48in50100ThermalIron steelSteel0.25
2in50100ThermalPVCPlastic0.0625
4in50100ThermalPVCPlastic0.0625
12in50100ThermalPVCPlastic0.1875

The columns definitions are as follow:

Column NameColumn TypeLink to TableLink to Column
Nominal SizeNominal SizeNominal SizeNominal Size
Minimum TemperatureTemperature--
Maximum TemperatureTemperature--
Insulation TypeStringInsulation TypeInsulation Type
MaterialMaterialMaterialMaterial
Material CategoryStringMaterialMaterial Category
Insulation ThicknessLength--

The table has the following attributes:

  • Standard
  • Max temperature
  • Min temperature

Where Used

This resource file is used and seen here:

Used in this appWhenIs seen as
Piping & Tubing 3D Part DesignInsulation creation