Synchronization Business Rule (EHFSynchronization_ExecutionOfUserSynchronization)

An opening ID is an entry point used to customize business logic.

Note: For more information about customization by business rules, see Installation and Setup: Customize: Behavior: Data Setup: Customization by Business Rules.

This page discusses:

General Information

This opening ID is invoked while using the Synchronize and the Extract commands.

Important: During the synchronization:
  • If the simulation option is activated, the execution of the business rule is not available for the added elements.
  • If the simulation option is not activated, the execution of the business rule is not available for the removed elements.

This opening ID is used to customize:

The table below provides you with information related to the definition of the Opening ID.

PLM Opening ID: EHFSynchronization_ExecutionOfUserSynchronization
Customization intent: Execution
Execution context:

Input Objects

Input objects must be of the following types:

  • ThisObject: Electrical component from the 3D flattened view.

    It can be : a segment, adaptable protective covering, corrugated tube protective covering, protective tape, rigid protective covering, single insert connector, backshell, shell, equipment, multi insert connector, terminal block, terminal strip, stud, splice, contact, conductor, conductor group, product (to retrieve at least the support and the mechanical part), feature for generic behaviour, or VPMInstance.

  • Parameters corresponds to the context object.

Context Object Parameters

Parameter NameTypeRead/WriteComments

Sample

The following sample