The following temperature settings and the gravity control specification
apply to the entire analysis:
- The melt temperature, which is the temperature at which polymer material enters at the
injection locations
- The default mold temperature, which is a uniform value applied everywhere in the mold. The app
overrides this value with any mold wall conditions that you define and with results
from the Mold simulation
- The ejection temperature, which is the temperature below which you can safely eject the part
from the mold
- The gravity direction, which is the downward direction in which gravity acts
- The mold-melt heat transfer coefficient, which describes the amount of heat transfer
that occurs between the polymer material and the mold wall
- The part insert temperature, which is the temperature of the part insert before
starting the Fill and Pack analysis