Listing Unpaired Sheet Connectors

You can list all the sheet connectors that are not paired. The verification is done on all the sheet connectors loaded in session.

Before you begin: In a diagram view,
  • Create and place equipment.
  • Create and connect a pipe to the equipment and end the other extremity as a sheet connector.
  1. From the Layout section of the action bar, click Check Sheet Connector .
  2. In the Check Offsheets dialog box, select the Check all orphan offsheets in session option in the list.
  3. Select one or several routable.
    Appear in the right area.
  4. The following actions can be performed:
    • To replace the displayed representation by the default representation (with unresolved text templates) defined in Data Setup, click Reset Sheet-Connector.
      Note: If no representation is defined in Data Setup, the default symbol replaces the current representation.
    • To highlight the selected sheet connector in the diagram view, click Switch to View.
      Notes:
      • If the selected sheet connector is located in another diagram view, the command opens the diagram view containing the sheet connector.
      • If multiple routable have been selected, the Switch to View option is not available.
    • To route the other extremity of the selected routable, click Complete Route, and then select a connection point. Click the diagram view to place the sheet connector.