General
- Display in 3D area
- Specifies whether engineering connections will be displayed in the 3D area when selected in the tree or in an instance involved in an engineering connection.
By default, this check box is cleared.
- Display child nodes of engineering connections in the tree
- Displays the child nodes of engineering connections (constraints, fasteners or simulations) in the tree.
By default, this check box is selected.
- By default, automatically position components
- Sets Automatically position components as default orientation for new engineering connections.
By default, this check box is selected.
- Lock automatically the engineering connection type at validation
- Allows you to automatically lock the engineering connection type at the end of the creation or edition.
By default, this check box is selected.
- Launch Engineering Connection Definition at product insertion
- Uses the Product Structure Design command behaviors when inserting an existing product or 3D part in the assembly.
By default, this check box is cleared.
- Notify contextual engineering connection creation
- Displays a message when you are creating a contextual engineering connection.
By default, this check box is cleared.
- Engineering Connections are duplicated when copying and pasting a component they move
- Duplicates the engineering connections in relation with a copied component during the paste. Only engineering connections that make repositionable the original component are accounted for.
By default, this check box is cleared.
Mechanism
- Add new engineering connection to the mechanism
- Adds automatically a new created engineering connection either the current mechanism or the first mechanism found (when there is no mechanism set as current) in the active product.
By default, this check box is cleared.
- Notify engineering connection addition to mechanism
- Displays a message to add or not a new created engineering connection either in the current mechanism or the first mechanism found (when there is no mechanism set as current) in the active product.
By default, this check box is selected.
Constraints Creation
- Position components to satisfy constraints
- Automatically positions components to comply with the constraint definition.
By default, this option is selected.
- Animate constraint changes
- Allows you to animate an assembly when creating or modifying engineering connection constraints.
By default, this check box is selected.
- Use direct manipulation for constraint creation
- Applies the direct manipulation behavior for constraint creation.
By default, this check box is selected.
Select the desired option:
- Use any geometry: to select any
geometrical element.
- Use published geometry of child components
only: to select any published element that belongs to child
components. For more information about publication, see
Assembly Design User's Guide: Managing a product Publication.
- Use published geometry of any level: to select any published element.
By default, the
Use any geometry option is
selected.
Note:
For more information about publication and engineering connections, see the dedicated article in the Knowledge Base.
Constraint Creation Order
The
Snap function utilizes a list of constraints in the order of creation.
You can modify the order of the constraints in the list when applying the
Snap command to the selected
geometrical elements.
Select the constraint type to reorder, and click the arrows on the right of the selection.
By default, the list is ordered as follows:
- Surface Contact
- Fix together relatively
- Fix together
- Coincidence
- Offset
- Angle
- Parallelism
- Perpendicularity
- Curvilinear distance
- Roll
- Slide
- Tangency
- Create verified constraints first
-
Determines whether verified constraints should be created using the Snap check box.
By default, this check box is cleared.
Interferences
- Check interferences at validation
-
Allows you to check for interferences when engineering connections are edited or created.
By default, this check box is selected.