Workshop Document

Workshop Document

Plate Fab Sketch Orientation

User Defined Sketch Orientation - Select the sketch orientation for the X, Y, Z coordinates.

By default, Top is selected.

Generate separate bevel view in Plate Fab Sketch

Generates a separate bevel view in the Plate Fab Sketch.

By default, is selected.

Profile Fab Sketch

Display zero points of EndCut features - Displays the zero points of a EndCut feature.

By default, Is not selected.

Display anchor points of opening features - Displays the anchor points of an opening feature.

By default, is not selected.

Generate Profile Fabrication Sketch Views with maximum scale - Displays the anchor points of an opening feature.

• Unchecked: Default behavior. Drawing view scale rounds off the nearest scale in the form of the ratio of integer digits. The computed scale is based on the predefined ratio range.
• Checked: Profile drawing is generated with maximum scale. A Maximum scale, as calculated in Front view (Near side view), is applied across all other views.

  The View geometry may or may not touch the view bounding window. It depends on to what extend the double value is rounding off as per the computations done.

  The definition of maximum scale is as follows:

  The bounding window dimension of the Front View (Near Side View) as defined in the Profile template is retrieved. These are termed as Sheet Dimensions.

  Ratio #1= Maximum length of Sheet Dimension along width / Maximum length of original View Dimension along width

  Ratio #2 = Maximum length of Sheet Dimension along height / Maximum length of original View Dimension along height.

  Maximum Scale = Minimum value between Ratio #1 and Ratio #2.

  This computed maximum scale is used to generate other views.

  Note: Since one scale is applied across all views, you may have to adjust the View Reference points of other views (Top and side views) for the view drawing to fit into the View Reference dimensions.

By default, is not selected.

Primary & Annotation - Primary Feature Generation Strategy

Generate Primary Attachment Line - Generates a primary line for attachment.

By default, is selected.

Primary & Annotation - Annotation Generation Strategy

With Curved IPM - Select from the choices:

• Opening
• Attachment Line
• Margin
• Edge Preparation

By default, is selected.