Dragging Of Elements

The Dragging Of Elements dialog box lets you customize options for direct manipulation. To access the dialog box, click Solving Mode next to Allow direct manipulation check box, in the Geometry tab.

Dragging of elements

Solving mode

The Solving mode contains the following options:

Standard mode
Select this mode to move as many elements as possible and also respect existing constraints.
Minimum move
Select this mode to move as few elements as possible and also respect existing constraints.
Relaxation
Select this mode to move elements by redistributing them over the sketch, globally speaking. This method solves element moving by minimizing energy cost.

By default, the Minimum move solving mode is selected.

Drag elements end points included
Select this check box to drag elements along with their end points.

By default, this check box is selected.