Topology Creation- G0 (Point)
- Where required, all commands should check if the selected input geometry are below the value
defined here. If not, the command should not produce a result and indicate which
elements are not below the value.
By default, the value is set to 0.005mm. - G1 (Tangency)
- Where required, all commands should check if the selected input geometry are below the value
defined here. If not, the command should not produce a result and indicate which
elements are not below the value.
By default, the value is set to 0.5deg. - G2 (Curvature)
- Where required, all commands should check if the selected input geometry are below the value
defined here. If not, the command should not produce a result and indicate which
elements are not below the value.
By default, the value is set to 5. - G3 (Torsion)
- Where required, all commands should check if the selected input geometry are below the value
defined here. If not, the command should not produce a result and indicate which
elements are not below the value.
By default, the value is set to 15deg.
|