Modifying the Bend's Radius

You can modify the radius value for all bends at a time or change it for a single bend or several bends.

Before you begin: Create a rebar.
  1. In the Rebar Creation dialog box, click the Bend tab.
    By default the Create bends check box is selected, bend is created on each sharp vertex of the wire.
    Note: Clear the Create bends check box only when an error occurs during the rebar layer update to determine if the bends are causing the error.
  2. Optional: Modify the default radius.
    • To change the default value for all bends, enter the value and click Apply.
    • To change the value for a bend at a time, select the bend check box and enter a new value.

The bends automatically reflect the new radius value.

 

See Also
About Bends