Replacing a Node

You can replace a node by another node or a port.

Before you begin: Create a rebar with the wire selection mode (picking point).
  1. Double-click a route.
    You switch to the CATIA Rebar Routing 3D Design app and a yellow symbol appears on each node of the route.
  2. Click next to the node you want to replace.
    The 3D Manipulator appears and the Bend Manipulator is activated.
    Note: If the node is the last node of the route, the Length Manipulator is directly activated. You need to press the A key to switch to the Bend Manipulator.
  3. On the context toolbar, click Replace Point .
  4. Select a port or a 3D point.
    The node is automatically replaced by the selected port or 3D point.