Modifying the Bend's Radius

You can modify the radius value for all bends at a time or change it for a single bend or several bends.

Before you begin: Create a rebar.
See Also
About Bends
  1. In the Rebar Creation dialog box, click the Bend tab.
    By default the Create bends check box is selected, bend is created on each sharp vertex of the wire.
    Note: Clear the Create bends check box only when an error occurs during the rebar layer update to determine if the bends are causing the error.
  2. Optional: Modify the default radius.
    • To change the default value for all bends, enter the value and click Apply.
    • To change the value for a bend at a time, select the bend check box and enter a new value.

The bends automatically reflect the new radius value.