ABQ_AM_EigenStrain_PatternBased_Activation

This parameter table type is used in special-purpose techniques for additive manufacturing.

This page discusses:

You must include a parameter table of type "ABQ_AM_EigenStrain_PatternBased_Activation" in the table collection. Only one set of data must be defined.

Parameter Table Type Definition

PARAMETER TABLE TYPE, NAME="ABQ_AM_EigenStrain_PatternBased_Activation", PARAMETERS=13
 FLOAT, 1.0, "Slice Height", , ,
 FLOAT, 1.0, "OriAX", , ,
 FLOAT, 0.0, "OriAY", , ,
 FLOAT, 0.0, "OriAZ", , ,
 FLOAT, 0.0, "OriBX", , ,
 FLOAT, 1.0, "OriBY", , ,
 FLOAT, 0.0, "OriBZ", , ,
 FLOAT, 0.0, "OriCX", , ,
 FLOAT, 0.0, "OriCY", , ,
 FLOAT, 0.0, "OriCZ", , ,
 STRING, "TotalTime", "Total/Step Time", , "TotalTime|StepTime", 
 FLOAT, -1e36, "Start Time", , ,
 FLOAT, +1e36, "End Time", , ,

Parameters

For reference, see Figure 1.

A scan pattern with four pattern patches.

Slice Height
Height of slice for scan pattern.
OriAX, OriAY, OriAZ, OriBX, OriBY, OriBZ, OriCX, OriCY, OriCZ
X-, Y-, and Z-coordinates of points a, b, and c for defining the orientation of the build system IJK and its origin. Point c is the origin of the system, point a must lie on the I-axis, and point b must lie on the IJ plane. Although not necessary, it is intuitive to select point b such that it is on or near the local J-axis.
Total/Step Time
Set to "TotalTime" to indicate that the print start and end times are in total time. Set to "StepTime" to indicate that the print start and end times are in step time.
Start Time, End Time
Print start and end times.