ABQ_AM_ThermoMech_PatternBased_Activation

This parameter table type is used in special-purpose techniques for additive manufacturing.

This page discusses:

You must include a parameter table of type "ABQ_AM_ThermoMech_PatternBased_Activation" in the table collection. Only one set of data must be defined.

 

See Also
Special-Purpose Techniques for Additive Manufacturing

Parameter Table Type Definition

PARAMETER TABLE TYPE, NAME="ABQ_AM_ThermoMech_PatternBased_Activation", PARAMETERS=13
 FLOAT, 1.0, "Slice Height", , ,
 FLOAT, 1.0, "OriAX", , ,
 FLOAT, 0.0, "OriAY", , ,
 FLOAT, 0.0, "OriAZ", , ,
 FLOAT, 0.0, "OriBX", , ,
 FLOAT, 1.0, "OriBY", , ,
 FLOAT, 0.0, "OriBZ", , ,
 FLOAT, 0.0, "OriCX", , ,
 FLOAT, 0.0, "OriCY", , ,
 FLOAT, 0.0, "OriCZ", , ,
 FLOAT, 0.0, "Recoater Time", , ,
 FLOAT, 0.0, "Print Start Time", , ,
 STRING, "TotalTime", "Total/Step Time", , "TotalTime|StepTime",

Parameters

For reference, see Figure 1.

A scan pattern with four pattern patches.

Slice Height
Height of slice for scan pattern.
OriAX, OriAY, OriAZ, OriBX, OriBY, OriBZ, OriCX, OriCY, OriCZ
X-, Y-, and Z-coordinates of points a, b, and c for defining the orientation of the build system I–J–K and its origin. Point c is the origin of the system, point a must lie on the I-axis, and point b must lie on the I–J plane. Although not necessary, it is intuitive to select point b such that it is on or near the local J-axis.
Recoater Time
Time for the recoater or roller to deposit one layer of raw material.
Print Start Time
Print start time.
Total/Step Time
Set to "TotalTime" to indicate that the print start time is in total time. Set to "StepTime" to indicate that the print start time is in step time. For more information, see Time Measures.