*PERIODIC MEDIA

ProductsAbaqus/Explicit

TypeModel data

LevelModel

Required parameters

INLET CONTROL NODE: Set this parameter equal to either the node number of the inlet control node or the name of a node set containing the inlet control node. If a node set name is chosen, the node set must contain exactly one node.
NAME: Set this parameter equal to the name of the periodic media.
ORIENTATION: Set this parameter equal to the name of an orientation definition (Orientations) used to define the trigger plane for periodic media block shuffling. The local z-axis is perpendicular to the trigger plane and points in the same direction as the media transport.
OUTLET CONTROL NODE: Set this parameter equal to either the node number of the outlet control node or the name of a node set containing the outlet control node. If a node set name is chosen, the node set must contain exactly one node.
TRIGGER NODE: Set this parameter equal to either the node number of the trigger node or the name of a node set containing the trigger node. If a node set name is chosen, the node set must contain exactly one node. The trigger plane is defined via a combination of trigger node location and the specified orientation.

Data lines to define a periodic media

First line

Element set label for all elements in the first block. (The element set used must be unsorted.)
Node set label for all nodes in the first block. (The node set used must be unsorted.)
Surface name defining the front edge nodes of the first block. The surface must be node-based, and the node set used in the surface definition must be unsorted.
Surface name defining the back edge nodes of the first block. The surface must be node-based, and the node set used in the surface definition must be unsorted.

Repeat this data line as often as necessary. Use one data line for each section of periodic media. The order of the periodic section is from inlet to outlet.