*CHANGE FRICTION

Change friction properties.

Use this option in conjunction with the FRICTION option to change the values of friction properties from step to step.

This page discusses:

Required, mutually exclusive parameters

ELSET

Use this parameter if the contact conditions have been modeled with contact elements or if friction is defined in connector elements. Set this parameter equal to the name of the element set containing the contact or connector elements for which the friction properties are being redefined.

INTERACTION

Use this parameter if the contact conditions have been modeled with surface-based contact pairs or general contact. Set this parameter equal to the name of the SURFACE INTERACTION property definition for which the friction properties are being redefined.

Optional parameters

AMPLITUDE

Set this parameter equal to the name of the amplitude curve (defined in the AMPLITUDE option) that gives the time variation of any changes in friction coefficients and allowable elastic slip throughout the step (Amplitude Curves).

If this parameter is omitted, transitions in these friction properties occur according to the value assigned to the AMPLITUDE parameter on the STEP option (see Defining an Analysis). Changes in friction properties other than the friction coefficient and the allowable elastic slip are always made immediately. Sudden changes in friction properties when the frictional stress is nonzero can cause convergence difficulties.

RESET

Include this parameter to reset the friction properties to their original values. When this parameter is used, no FRICTION option is needed to redefine the friction properties.

There are no data lines associated with this option.