Required parameters
- NAME
Set this parameter equal to a label that will be used to refer to the
fastener property.
Data lines
to specify the fastener properties
- First line
Radius, r.
- Second line
First degree of freedom constrained. See
Conventions
for a definition of the numbering of degrees of freedom in
Abaqus.
If this field is left blank, all degrees of freedom will be constrained.
Last degree of freedom constrained. If this field is left blank, the degree
of freedom specified in the first field will be the only one constrained.
Repeat this data line as often as necessary to specify
constraints for different degrees of freedom. When the ORIENTATION parameter is specified on the associated
FASTENER option, the degrees of freedom are in the specified local
system in the initial configuration; otherwise, they are in the default local
system. In either case these directions will rotate with the reference node in
large-displacement analyses (when the NLGEOM parameter on the
STEP option is set equal to YES).