*NSET

Assign nodes to a node set.

This option assigns nodes to a node set.

This page discusses:

Required parameters

NSET

Set this parameter equal to the name of the node set to which the nodes will be assigned.

Optional parameters

ELSET

Set this parameter equal to the name of a previously defined element set. The nodes that define the elements that belong to this element set at the time this option is encountered will be assigned to the node set specified. The UNSORTED parameter cannot be used with this parameter.

The ELSET and GENERATE parameters are mutually exclusive.

GENERATE

If this parameter is included, each data line should give a first node, n1; a last node; n2; and the increment in node numbers between these nodes, i. Then, all nodes going from n1 to n2 in steps of i will be added to the set. i must be an integer such that (n2-n1)/i is a whole number (not a fraction).

The ELSET and GENERATE parameters are mutually exclusive.

INSTANCE

Set this parameter equal to the name of the part instance that contains the nodes listed on the data line. This parameter can be used only at the assembly level and is intended to be used as a shortcut to the naming convention. It can be used only in a model defined in terms of an assembly of part instances.

UNSORTED

If this parameter is included, the nodes in this node set will be assigned to the set (or added to the set if it already exists) in the order in which they are given. This parameter will be ignored if the ELSET parameter is used.

If this parameter is omitted, the nodes in the set are sorted into ascending order of their node numbers, with duplicates eliminated.

Data lines if the GENERATE parameter is omitted

First line
  1. List of nodes or node set labels to be assigned to this node set. Only previously defined node sets can be assigned to another node set.

Repeat this data line as often as necessary. Up to 16 entries are allowed per line.

Data lines if the GENERATE parameter is included

First line
  1. First node in the set.

  2. Last node in the set.

  3. Increment in node numbers between nodes in the set. The default is 1.

Repeat this data line as often as necessary.

There are no data lines when the ELSET parameter is specified