ABQ_PHASE_TRANS_Martensitic_TTT_Constants

You use this parameter table type to specify constants for the time-temperature-transformation (TTT) diagram for a martensitic transformation.

This page discusses:

See Also
Modeling Metallurgical Phase Transformations

Products Abaqus/Standard

You can include a parameter table of type "ABQ_PHASE_TRANS_Martensitic_TTT_Constants" in the material definition to specify constants for the time-temperature-transformation (TTT) diagram for a martensitic transformation whose input option is set to TTT in the parameter table of type "ABQ_PHASE_TRANS_Transformations".

The parameter table must have a unique label of "ABQ_PHASE_TRANS_Trans_NameOfTransformation_TTT_Constants", where NameOfTransformation is the name of the transformation defined in the parameter table of type "ABQ_PHASE_TRANS_Transformations".

The parameter table of type "ABQ_PHASE_TRANS_Martensitic_TTT_Constants" can define only one set of data.

Parameter Table Type Definition

, NAME="ABQ_PHASE_TRANS_Martensitic_TTT_Constants", PARAMETERS=2
 FLOAT, , "Starting Proportion", , ,
 FLOAT, , "Ending Proportion", , ,

Parameters

Starting Proportion
Relative total volume fraction of parent phases at the start of the transformation. This value must be between 0 and 1.
Ending Proportion
Relative total volume fraction of parent phases at the end of the transformation. This value must be between 0 and 1.