ABQ_PHASE_TRANS_SolidificationMap_Constants

You use this parameter table type to specify constants of the solidification map for modeling grain morphology.

This page discusses:

See Also
Modeling Metallurgical Phase Transformations

Products Abaqus/Standard

You must include a parameter table of type "ABQ_PHASE_TRANS_SolidificationMap_Constants" in the material definition to specify constants of the solidification map for modeling grain morphology. Only one set of data can be defined.

Parameter Table Type Definition

, NAME="ABQ_PHASE_TRANS_SolidificationMap_Constants", PARAMETERS=2
 FLOAT, , "Critical Solidification Rate", , ,
 FLOAT, , "Constant Grain Size LogR-LogG Slope", , ,

Parameters

Critical Solidification Rate
Solidification rate below which the grain is fully columnar.
Constant Grain Size LogR-LogG Slope
LogR-LogG slope along which the grain size is constant.