Creating Openings on Panel and Plate

Creating a Sketched Opening

This topic describes how to create an opening by sketching the contour.

  1. In the Applied on box, select a panel or a plate on which you want to create the opening.
  2. Click Create Sketch Opening .
  3. In the Sketch Opening dialog box, define the sketch opening:
    1. In the Category list, select the opening type.
    2. Click to sketch the opening contour.
        Note:
    3. Select the required forming mode.
    4. From the Extrusion list, select the extrusion type: UpToLast or Limit1/Limit2.

      The extrusion must intersect the support of the plate/split plate.

    5. Click Apply.
      The inputs are applied.
    6. Click OK.
    The opening is created.