Scallop on Panel and Plate lets
you create scallops on the corners or at the edge of panels and plates.
Scallops are the openings created at intersections for draining water
and venting out air.
In the
Applied on box, select a panel or a plate on
which scallops are to be created.
You can select multiple panels and plates.
The possible corners on which the scallops can be created,
are listed in the dialog box. The corners are highlighted in the
3D area.
The
Type column lists the type of positioning
strategy.
Select the required rows and click
Create Scallop.
In the
Scallop Definition dialog box, define the
scallop parameters.
From the
Category list, select the category for
scallop.
Under
Position Strategy, select two limits.
By default, the scallop positioning type is
Limit/Limit. If you do not select any row,
the scallop is created with the
Limit/Offset positioning strategy.
Select the contour type and contour name in the respective
lists.
Note:
The snipe and clearance types are available only for the
Limit/Limit position strategy.
The Parameters area displays the
contour parameters and a bitmap image of the contour.
Click
Apply to apply the inputs.
Click
OK to save the applied inputs.
The scallop parameters are defined. The contour type and
contour name of the scallops are displayed in the respective columns of the
Scallop dialog box. The scallops are created.
Scallop on Corner
.
