-
In the
Plate box, select a plate
on which the flange is to be defined.
-
In the
Edge box, select one or more highlighted
edges.
-
In the
Mode list, select
Centered or
Tangent.
-
In the
Flange Width box, enter a value (say
300mm).
You can use one of the following options to select a reference for width calculation:
Option | Reference |
---|
 |
Inner face |
---|
 |
Outer face |
---|
-
In the
Angle box, enter the required bending angle
value (say
60 degree).
-
In the
Radius box, specify radius between the plate
and the flange.
- Optional:
To create a flange without increasing the overall length of the plate, select
one of the following Trim options:
Option | Description |
---|
Without Trim |
 |
Inner Trim  |
 |
Outer Trim  |
 |
Where, L is length of the plate. The
above table shows the representations of the physical objects created after
synchronization.
- Optional:
Under the
Limits area, select the start and end limits.
You can select reference planes or surfaces to limit the flange.
- Optional:
Under the
End Cut area:
-
In the
Distance box, enter the distance from the
free edge, to position the end cut.
-
In the
Angle box, enter the required value.
The angle is always counted from the vertical edge of the
flange.
-
In the
Radius box, enter the end cut radius.
You can set the same end cut parameters for start and end
extremities, by keeping the chain mode active.
|