-
From the Category list, select an appropriate category
for the stiffener on free edge.
-
In the Material & Orientation tab:
-
Select the appropriate material and section for the stiffener.
-
Set the orientation of the stiffener.
If you are unable to find the selected section reference, check the following: - The section reference is available in the database.
- There are no duplicate section references in the database.
- The section reference has the section standard attribute specified in its properties.
-
In the Geometry tab, in the
Plate\Panel box, select a panel to attach the
stiffener.
As soon as the panel is selected, the free edges of the panel or the openings
on it are highlighted in the 3D area.
-
In the
Support box, select the required edge or
opening.
- Optional:
In the Offset box, enter the offset value
for the stiffener on free edge from the selected support.
- Optional:
Under the
Limit area:
-
Select the start and end limits.
-
Specify the offset and normal offset values.
-
Define the delimitation type.
- Optional:
Under the
Angle area, specify the required value in the
Web Angle box.
By default, the web of a stiffener is placed perpendicular to the
panel.
|