The property mapping refers to the possibilities of copying properties
from one object to be applied to other object. This helps in reusing the
properties defined to one structural element. The following table shows an
overview about the properties that to be copied from one object to another.
Object Providing
|
Property
|
Object Receiving
|
|
With Geometry tab active
|
With Material and Orientation tab active
|
|
Panel
|
The following properties are copied:
- Category
- Support
- Support Offset
- Limits
- Material and Thickness
- Orientation Side
- Thickness Offset mode
- Thickness Offset
|
The following properties are copied:
- Material and Thickness
- Orientation Side
- Thickness Offset mode
- Thickness Offset
|
Panel
|
Stiffener
|
The following properties are copied:
- Category
- Plate
- Support
- Support Offset
- Limits
- Angle Mode
- Material and Section
- Plate Side
- Section orientation
- Anchor point
- Thickness Offset
|
The following properties are copied:
- Material and Section
- Plate Side
- Section orientation
- Anchor point
- Thickness Offset
|
Stiffener
|
Panel
Stiffener Support
|
Support
|
|
Stiffener
|
Stiffener on Free Edge
|
The following properties are copied:
- Category
- Plate
- Support
- Support Offset
- Limits
- Angle
- Material and Section
- Plate Side
- Section orientation
- Anchor point
- Anchor point Offset
|
The following properties are copied:
- Material and Section
- Plate Side
- Section orientation
- Anchor point
- Anchor point Offset
|
Stiffener on Free Edge
|
Beam
|
All properties according to each beam type
|
The following properties are copied:
- Material and Section
- Plate Side
- Section orientation
- Anchor point
- Angle
- Offset U
- Offset V
|
Beam
|
Panel
Stiffener Support
|
Transversal
|
|
Beam
|
Panel
Stiffener Support
|
Longitudinal
|
|
Beam
|
For the
Opening command, the following properties are
copied:
Object Providing
|
Property
|
Object Receiving
|
Opening/Standard Opening
|
The following properties are copied:
- Category
- Applied to
- Support and Direction
- Extrusion Mode ( Limit1 & Limit 2 )
- Type
- Position parameters
- Contour parameters
|
Opening/Standard Opening
|
Opening/Standard Opening
|
The following position properties are copied:
- Position parameters
- Angle
|
Opening/Standard Opening
|
Opening/Standard Opening
|
The following contour properties are copied:
|
Opening/Standard Opening
|