Mapping Parameters Using the Immersive Parameters View

You can use the immersive parameters view to map parameters and view existing parameter mappings.

See Also
Parameter Mapping Compatibility
Immersive Parameters View
  1. Open a simulation process.
  2. Select the activity that contains the parameters that you want to map.
  3. From the View section of the action bar, click .
    Ports representing the parameters appear on the top of the activity.

    When the dataflow panel is activated, the dataflow paths being shown are filtered based on your selection. If you select two or more activities, only the paths between the source and destination activities will be shown. If you select a parameter from the table while the Immersive View is shown, corresponding data paths are highlighted.

  4. If you change the parameter visualization mode to one port per parameter, you can drag a port from one activity to another parameter port or activity.