Run the Simulation

Run the simulation to predict the O-ring's behavior as it is pressed into the groove.

By default, the simulation runs on your local machine using an embedded license. Depending on your configuration, you may need to choose to run the simulation on a remote machine.

  1. From the Simulate section of the action bar, click Simulate .
  2. From the Location options, select Local interactive.
  3. Accept all other default settings, and click OK.
    The Simulation Status dialog box appears. You can use this dialog box to monitor the progress of your simulation and diagnose errors.
  4. When the simulation completes, close the Simulation Status dialog box.

    The simulation results open in Physics Results Explorer.