Creating Bends

Bend lets you create a bend on non-connex walls, flanges, or stamps, and with a constant radius value.

Before you begin: Create two perpendicular walls.
  1. Select the first wall as Support 1 and the second wall as Support 2.

    The left and right endpoints are identified. You can click the arrows on the geometry to invert the walls orientation.

    Important: The Radius box is unavailable as it is driven by a formula which is defined when editing the Sheet Metal parameters.
  2. Right-click the Radius box and select Formula > Deactivate.
  3. Specify a radius value, an angle, and then click Preview.


 

See Also
Creating Bends from Walls