About the Selection of the Spine

This section provides information about the selection of the spine.

Whatever the type of the swept wall you wish to create, you first need to select one or more contiguous edges to make up the spine along which the contour, either pre- or user-defined, will be swept.

  • You can manually select one or more edges
    Selection without propagation

    Resulting flange without propagation

  • You can select an edge and click Tangency Propagation: all contiguous and tangent edges are selected. In this case, to remove an edge from the selection, you need to manually select it and remove it.
    Note: Only extremity edges can be removed without breaking the continuity between edges.
    Selection with propagation

    Resulting flange with propagation