Creating Half Pierce Stamps

You can create half pierce stamps by specifying the punch geometrical parameters.

Before you begin: Create a wall.
  1. From the Refine section of the action bar, click Circular Stamp .
  2. Select a point on the top face of the geometry.
    The Circular Stamp Definition dialog box and a grid appear to help you position the circular stamp.
  3. Select Half-pierce.
  4. Define the following parameters:
    OptionDescription
    Height Total height
    Outer The height is computed from the bottom of the thickness to the outer boundary edge
    Inner The height is computed from the top of the thickness to the inner boundary edge

    You can click Sketch to edit the positioning sketch.

    Diameter Major diameter
  5. Click OK.
    The half pierce is created and the tree is updated accordingly.
    Warning: You cannot create a cutout that partially overlaps a half pierce stamp, but you can create a cutout on the bottom of a half pierce stamp.