Insert

You can use create a core or a cavity on the required part of the mold with the insert.


Before you begin:
  1. Define the pulling direction, parting lines, and parting surfaces for the mold.
  2. Apply shut-off surfaces where required.
  3. Create a profile using the Sketch section of the action bar. The profile must include the parting surface.
  1. From the Mold Features section of the , click Insert .
  2. In the dialog box, from the work area select the sketch profile to insert.
  3. From the work area, select the shutoff surface or mold body.
  4. Optional: To add draft to the core or cavity, click the Enable draft and enter the Draft angle.
  5. Click .
    Note: To edit the Insert, double-click the insert in the Design Manager.