-
From the Sheet Metal section of the action bar, click User Flange
.
-
Select a spine or an edge.
Note:
You can select all the tangentially contiguous edges forming the spine.
-
Select the profile.
When you select an edge, the contextual icon Select Tangent Edges appears near the selected edge
in the geometry. You can click to select all tangent edges to the selected
edge.
The selection box is updated with the selected edge and a preview of the user flange
is created. To remove the selections made, click , and select
Clear all selections.
-
Optional: From the Limiting Geometry, select
the reference 1 and reference 2 to limit the geometry.
Note:
Choose the Limiting Geometry references from one of
these: reference plane, end vertex of an edge, or point on the edge.
-
Optional: From the K-Factor, find the
Override default settings check box and enter the required K-Factor.
-
Click for
OK.
|