Placing Components

You can now place components on your design, either on Component Specifications or on independent points.

Click Play to watch the video:

  1. From the Component Use section of the action bar, select Place Components and the plate where you have defined Component Specifications.
  2. Pick the callout of a Nesting Guide Component Specification.
    1. From the context toolbar start the PLM Search and select Nesting_guide_sizable.
    It is positioned on the Component Specification.
  3. Still from the context toolbar, select All Compatible Component Specifications and Impacts.
    1. Validate.
  4. Repeat with the Cap Screw Component Specifications.

    Note: Your choices have been kept.

    1. Select No Impacts instead of Impacts.
  5. Select Place Components and pick a point on the plate (not an Component Specification).
    1. Start the PLM Search from the context toolbar that is attached to the Z Axis on the pick.
    2. Select the EyeBolt.
      The EyeBolt is placed on the point you have picked.
    3. Select No Impact and validate.
    4. Use the Compass to position the Eyebolt as wanted. Validate
  6. Click the initial EyeBolt. From its context toolbar, select Move and position this EyeBolt as wanted.