Analyzing and Verifying Interference Simulation Results

Analyze Interferences lets you analyze the results of an interference simulation, and verify the interferences.

  1. Select the required interference from the interference simulation list.
    • The 3D geometry is reframed with interference curves appearing based on the selected interference.
    • If the selected interference has a slide created for it, the slide is applied automatically provided that the corresponding markup is active. If there are several slides created for the selected interference, the first related slide in the active markup is applied. This behavior is applicable only when the review is created with an interference simulation as a context.
    Notes:
    • If you select Color according to interference under Color Overload, available in Me > Preferences > Digital Mock-up > Interference Check > Interference Display tab, colors are applied to the interfering parts according to their interference type.

      By default, colors applied to the interfering parts are as below:

      • Clash:
      • Contact:
      • Clearance:

    • These colors are applied based on the system status. You can change these colors as required.
  2. Use the commands on the context toolbar to modify the appearance and to measure the parts in 3D area.
  3. Select an interference in the interference list, and click Slide on the action bar.

    The current interference results are captured in the slide. The slide is created with the same name as that of the selected interference.

 

See Also
Computing Interferences