Switching a 3D Part to a Product

You can switch a 3D part to a product.

  1. Open an assembly containing a 3D part.
  2. Select a 3D part.
  3. In the Tools section of the action bar, click Switch to Product .
    The 3D part is now a product.

    A message informs you that the 3D part is successfully switched to a product.

Important:
  • The multiselection is not allowed with this command.
  • The name of the representation does not change. If needed, you can rename this new product.
  • It is recommended to save after executing this command. If you do not save, the deletion of the 3D part representation leads to an un-affiliated product representation in the database.