Adding an Existing Document

You can add an existing document to a model version.

Note: You cannot add an existing specification to a model version.

Before you begin: Open the model version. For more information, see Opening a Model Version.
See Also
Viewing Information About a Document or Specification
  1. Select the Documents tab.
  2. From the page toolbar, select New > Add Existing .
    The search results list all available documents that you can add to a model version.
  3. From the search results, select one or more existing documents to add to the model version.
  4. Click OK to add each of the selected files to the model version as a document.

Each selected document is added to the Documents tab for the model version.

Tip: There are other ways that you can add an existing document to a model version:
  • If there are not any documents listed, drag a document from 3DSearch results into the body of the Documents tab.
  • If there are not any documents listed, click Search In Content in the body of the Documents tab, then select one or more documents from the 3DSearch results.
  • If there are already documents listed, drag a document from 3DSearch results into the header of the table on the Documents tab.