Installation and Administration Roadmap

This section describes the software components that must be installed along with tasks that must be performed for a successful installation of AutoVue 2D Viewer (C2D).

To implement AutoVue 2D Viewer, certain software components must be installed, set up, and configured to match your business processes and environment.

These supporting components include the application server, and 3DSpace. The table below contains a list of supporting components that need to be installed and configured along with a reference for more information. For AutoVue 2D Viewer tasks, the table provides cross references to the sections of this guide that describe those steps and options.

TaskReference

Installing AutoVue 2D Viewer Server

Installing AutoVue 2D Viewer Server

Installing AutoVue 2D Viewer Client

For installing AutoVue 2D Viewer in GUI and TUI mode, see Installing AutoVue 2D Viewer Client.

Installation Setup

You can install AutoVue 2D Viewer, with different FCS and MCS combinations depending on the network, see About AutoVue 2D Viewer Installation Setup.

Post Installation Tasks

For configuring, upgrading, and registering formats, see Post Installation Tasks.

Settings and Configurations

For configuring prinitng attributes, FCS settings for xrefs, markups and FCS-MCS setup combination, see Settings and Configuration.