Creating a Parting Line

You can create a parting line, that is the geometrical junction line of the mold on the molded part either from a shape, or from the pulling direction defined on this shape.

See Also
About Parting Line
  1. From the Molded Part section of the action bar, click Parting Line , and select a pulling direction.
  2. Select the pulling direction and the type of parting line to create under Options .
  3. Alternatively, select a shape and an edge.
  4. Close any open parting line, either by selecting one arrow and chaining edges as instructed, or by creating geometry such as a spline or a reflect line.
  5. Under Analysis , verify and solve possible problems.