Eligible Support Types for Resultant Sensors

The loads and restraints that are eligible for selection as support for a resultant sensor depend on how the load or restraint was defined. You can select a load as support only if its support was a point or an edge.

This page discusses:

See Also
Creating Resultant Sensors

Restraints

You can use a restraint as support for a resultant sensor only for a subset of restraints that depend on restraint type and the type of support used in the restraint definition. The full list of eligible restraint definitions and support selections follows.

Restraints Eligible support
Clamp All prescribed supports
Displacement Restraints All prescribed supports
Planar Symmetry Face, point, or edge
Bolt Restraint (includes meshed bolts) Pre-tension node location
Ball Joint Cylindrical surfaces and rigid reference nodes
Hinge Cylindrical surfaces and rigid reference nodes
Slider Coplanar surfaces

Loads

In most cases, you can select a load as support for a resultant sensor only if the load was defined with a point or an edge as its own support. The full list of eligible load definitions and support selections follows.

Loads Eligible support
Force Point
Remote Force Edge
Torque Point
Remote Torque Edge
Bolt Force Virtual bolt connection. The resultant sensor value is available at the pre-tension node location.
Bolt Displacement Virtual bolt connection. The resultant sensor value is available at the pre-tension node location.
Applied Translation Edge or point
Prescribed Temperature Edge or point