About Editing Multi-Constraint

Modify a Tolerance

You can modify a tolerance either in the Edit Multi-Constraint dialog box or directly from the work area.

1. In the work area, select the constraint for which you want to modify the tolerance.

   The Constraint Definition dialog box is displayed.

2. Right-click in the Value box and select Tolerance > Edit.

Delete a Tolerance

You can delete a tolerance either in the Edit Multi-Constraint dialog box or directly from the work area.

1. In the work area, select the constraint for which you want to delete the tolerance.

   The Constraint Definition dialog box is displayed.

2. Right-click in the Value box and select Tolerance > Suppress.

Restore a Tolerance

In the Edit Multi-Constraint dialog box you can restore the tolerances. This applies to the selected constraint. It restores the tolerance to its initial state, when the multi-edit command was launched.

1. Select the constraint for which you want to restore the tolerance.

2. Click Restore Initial Tolerances.

   Important: If tolerances did not exist, and were created later on, they will be deleted. If tolerances did exist, and were deleted or modified later on, they will be restored to their initial values.

Multi-Select Constraints

1. Select the constraints for which you want to apply a tolerance.

2. Enter a value in the Maximum tolerance and Minimum tolerance boxes. The tolerances are displayed on the sketch with the corresponding dimension.
   
   

   Important: The display of the tolerances and their edition in the multi-edit command is done only for dimension constraints of the sketches. The display of the tolerances is not done as in the standards, since it is just a way to have a global view of tolerances.