Adjusting Relationships between Harness Components

You can edit the relationships between the components covering a harness.


Before you begin: Open an electrical geometry containing supports and protective coverings.
See Also
About Protective Coverings
  1. From the Protection section of the action bar, click Adjust .


  2. Select the component you want to adjust:
    • The retainer
    • The protective tape covering.

    In our example, select the yellow protective tape covering the segment.

  3. Select the component you want to place it over:
    • The segment
    • The protective covering
    • The support, if your first selection was not a retainer.

    In our example, select the corrugated tube.

    The protective tape is adjusted to cover the corrugated tube.

    Note that the retainer is partially hidden by the protective tape.

  4. Click Adjust and select first the retainer and then the protective tape.
    The protective tape is adjusted and it no longer covers the retainer.