About Chamfers as Local Modifiers

Chamfer creates a chamfer by removing or adding a flat section from a selected edge. It creates a beveled surface between the two original faces common to the selected edge.

This page discusses:

See Also
Creating Chamfers as Local Modifiers

About Control Types

There are following types of control types:

  • Length/Angle
  • Length1/Length2
  • Chordal length/Angle
  • Height/Angle
  • Hold curve/Angle
  • Hold curve/Length

About Propagation Modes

Two propagation modes are available:

  • Tangency: Tangency is taken into account to fillet the entire edge and possible tangent edges.

  • Minimal: Edges tangent to selected edges can be taken into account to some extent. The app continues creating the chamfer beyond the selected edge whenever it cannot do otherwise.