On premises:
01_3DX_Living_Heart_Simulation_Experience.3dxml
|
Run the electrical and mechanical
simulation sequentially. The results of the electrical model are used to drive
the mechanical model. You use this simulation process to run the default,
unmodified Heart Model.
|
On cloud:
3DX_Living_Heart_Simulation_Cloud_Experience_Type_01.3dxml
|
On premises:
02_3DX_Living_Heart_Simulation_Experience.3dxml
|
Run a mechanical simulation based
on a pre-existing set of results from the electrical model. You use this
simulation process when you have made no changes to the default, unmodified
electrical model, but you have modified the mechanical model.
|
On cloud:
3DX_Living_Heart_Simulation_Cloud_Experience_Type_02.3dxml
|
On premises:
03_3DX_Living_Heart_Simulation_Experience.3dxml
|
Run a mechanical simulation when
you have modified any mechanical properties of any portion of the model,
including the properties related to the blood flow model. You should also run
this simulation process if you have modified any of the loads, boundary
conditions, or constraints in the
Pre-Load step.
|
On cloud:
3DX_Living_Heart_Simulation_Cloud_Experience_Type_03.3dxml
|
On premises:
04_3DX_Living_Heart_Simulation_Experience.3dxml
|
Run a mechanical simulation when
you have modified any mechanical properties of any portion of the model,
including the properties related to the blood flow model, and you have remeshed
any portion of the model. You must remesh the electrical model before executing
this simulation process. The process remaps the fiber orientations in both
models, re-runs the electrical simulation, and uses the new set of results from
the electrical model to drive the mechanical simulation.
|
On cloud:
3DX_Living_Heart_Simulation_Cloud_Experience_Type_04.3dxml
|
On premises:
05_3DX_Living_Heart_Simulation_Experience.3dxml
|
Run only the electrical
simulation. You use this simulation process after modifying the electrical
model.
|
On cloud:
3DX_Living_Heart_Simulation_Cloud_Experience_Type_05.3dxml
|