Context Toolbars

Context toolbars are smart toolbars that contain only those commands that can be applied to the current selection.

This page discusses:

Middle Segment Selection

Orthogonal Routing
Creates a route between a start node and an end node by selecting a solution of routing.
A set of all possible routing solutions are displayed from start to end point from which one route solution can be selected.
See Routing with Alternate Paths.


Segment Manipulator
Translates a route segment according to the global or segment axis.
Drag the arrows to translate the route segment. A preview of the route is displayed while you drag the arrow.
See Translating a Route Segment.


Slope
Creates a slope on the route to allow the fluid flows due to the gravity from a high point to a low point.
See Creating a Slope on a Route.


Automatic Offset
Adds an automatic offset when two routes intersect.
See Creating an Automated Offset.


Manage Angle without Network Impact
See Defining the Bend Angles of a Segment


Delete Segment
See Deleting a Segment


Orient Section
See Orienting a Non Circular Route

Bend Selection

Replace Node
Replaces the selected node by another node or a port.
See Replacing a Node.
Delete Node
Deletes the node on which the Bend Manipulator is activated.
See Deleting a Node.


Modify Bend
See Modifying a Bend or a Segment
Route on Robot base
See Routing along a Surface


Remove Local Bend radius
See Removing a Local Bend Radius


Move Node
See Moving a Node


Select Point
See Selecting a Virtual Point


Convert to 3D Point
Converts the selected point into a 3D coordinate point.

Geometry Selection



Branch
Creates a branch from or to an existing route.
See Creating a Branch from and to an Existing Route.


Parallel Routing
Allows you to select a guideline route and its nodes to create a subordinate route from it.
See Creating a Parallel Route.