Repeating an Action

You can perform the same action from the context toolbar repeatedly without re-selecting the action.

Before you begin: You must be in the Surface Mesher or Tetrahedron Mesher.
See Also
About Mesh Context Toolbars
  1. Select a support from your model or click in the 3D area.
    The context toolbar appears.
  2. From the context toolbar, select Repeat Mode .
  3. From the context toolbar, select the action that you want to use.
  4. Complete the selections or steps for the selected action.

    Upon completion, the action immediately begins again.

  5. To stop repeating the action, do one of the following.

    • Press the Esc key.
    • Click in the 3D area to open the context toolbar, and toggle off the repeat tool.