Creating Injection Points and Gates

You can create Injection Points and Gates on a parting surface or a parting line. An Injection Point defines the position and type of the associated Gate. Each Gate is created up to the reference surface.

See Also
About Injection Points
  1. From the Mold Design section of the action bar, click Injection Point .
  2. Open the 3D part or the Skeleton.
  3. Select a Pulling Direction , and a Reference Surface or Curve .
  4. Pick a point on the Parting Surface or Line.
  5. Drag the Robot to position the point.
  6. Select the Injection Point orientation on the context toolbar.
  7. Select a Gate type on the context toolbar.
  8. In the dialog box, specify on which side the Gate is created.
  9. Define Gate parameters. .
  10. Select additional creation options .
  11. Select Create a Gate .