Wall Thickness

This section describes the Wall Thickness table and how you can customize it.

This page discusses:

Overview

This resource file is a discrete list of all possible wall thicknesses of a pipe or tube for a single standard.

In Data Setup, this table should be assigned to the Wall Thickness item in the resource table of Piping/Tubing Design Resources.

Rule Customization

A typical Wall Thickness table is shown below.

To customize the table, enter all possible wall thickness of a pipe or tube for a single standard.

Important: You must create one table for each standard that you use.
0.5mm
0.75mm
1mm
1.5mm
2mm

Sample Resource File

The default location of Tubing_SSTL_WallThickness.xls is

..\startup\EquipmentAndSystems\Piping\Standard\SSTL\

Note: The app optional content is not automatically installed along with the code. Contact your administrator if you must install the files you need. For more information, see Install Optional Content. You can also see Installation and Setup:Install: 3DEXPERIENCE Platform: Installing 3DEXPERIENCE Platform Services for the First Time: Installing Services One-by-One: Native Apps: Installing Native Apps: Installing a Native App.

Where Used

Used in this appWhenIs seen as
Piping & Tubing 3D Part DesignCreating partsWall Thickness list in Typed Part dialog box.