Recommendation:
- Select a network and its mesh.
- Verify and adjust the surface type.
- Verify and adjust the location of sharp edges in the network.
- Select areas to fill.
- Compute and verify globally the result.
- Optional:
Fine-tune parameters and recompute the current selection.
- Verify locally the results where required.
- Adjust parameters and recompute the already computed surface where required.
- Continue with the remaining areas to fill.
Surfaces Network takes a curves network and a support mesh as input.
You can control:
- The maximum deviation between the surface and the mesh,
- The continuity (G0 or G1) between neighboring surfaces.
Surfaces Network allows edition afterward and supports a scenario such
as:
- Start generating the surface in Surfaces Network
- Save the current state and exit.
- Resume later and continue surface generation.
Wire refers to a patch/cell of the curves network.