You can unfold the flexible board and fold it again.
Before you begin: Rigid Flex Parameters are necessary for Fold/Unfold command. Otherwise an error message appears.
Open an electrical geometry (flexible board), in the Fold view:
Important:
The flexible board must be UI-active. If the command is launched on another object except a flexible board, a warning appears:
The current active object is not a flexible board so this command cannot be used.
From the Rigid Flex section of the action bar, click Fold / Unfold a Rigid board assembly to unfold the flexible board.
Note:
Constraint areas, holes, cutouts and placed components are natively integrated in the Fold / Unfold views of the flexible board. Nevertheless the not drilled holes are not integrated to the Unfold view.
Warning:
You cannot use the Fold / Unfold command of the Sheet Metal Designapp for Flexible Circuit Board Design features.